Corrected for Linearity and Temperature
Accurate to 0.02% ,10°C to 50°C
Can be calibrated up to 2.2 Tesla
With or without display
Probe head in either encapsulated or PCB
Minimum standard cable length of 2 meters
Power Supply not included
HPCS Analogue Corrected Hall Probe
Analog Corrected Hall Probe with choice of maximum field up to 2.2 Tesla.
The HPCS analog probe can be fitted with an encapsulated hall sensor or mounted in a standard PCB.
The probe has fast response rate of 200khz.
Accuracy is at ±0.02% of full scale + 0.01% of field +0.00002 tesla up to 10khz.
Probe
Encapsulated Hall Sensor Head
Ceramic substrate with epoxy encapsulation
Length: 14mm – see separate diagram sheet
Cross Section: 2.0mm thick (in field direction) x 5mm wide.
Sensor position: 1.5mm from free end of probe
Cable length: 2.0metres min., 30 max. metres
(specified by customer)
Polarity output is positive when field vector enters epoxy side of
probe
PCB Style -Probe Head
Epoxy-glass laminate (standard pcb material)
Length: 100mm (min.) from cable strain relief to Hall sensor
Cross section: 1.6mm thick (in field direction) x 10mm wide.
Sensor position: 2.5mm from free end of probe
Cable length: 2 meters min., 30 max. metres (specified by customer)
Polarity : output is positive when field vector enters flat side of probe
Operating conditions for full correction
Magnetic field: bipolar field range as specified in model code
Temperature: 10°C to 50ºC
Output
Voltage: bipolar output range as specified in model code
Accuracy: ±(0.02% of full scale + 0.01% of field +0.00002) tesla
±1% approx for field components above 10kHz
Bandwidth (small signal): 0 to >200kHz (-3dB point)
Bandwidth (full output): 0 to 35kHz sine wave (20 volt peak-to
peak output)
Slew rate: >2V/ms
Noise level: < 1mV p-p (over bandwidth 0 to 10kHz,
>0.5T full- scale)
Output Impedence < 10 Ω
Output load 2 kΩ min.
Power input requirement
24V nominal ac or dc
Red LED power indicator
AC: 28V max., 17V min., 3VA nom.
DC: 36V max., 20V min., 2W nom.
Red LED indicates “power on”
Over temperature output
Isolated collector and emitter of optocoupler,
We can arrange shipping with DHL Express which can be added in the cart at checkout.
Otherwise you may choose to use your own shippping provider (FEDEX,UPS,DHL) at the buyer's expense.
We shall use your supplied shipping account number.
Kindly provide your shipping account provider and number.
